 |
 |
17 Jun 2002
Paper airplanes propelled by 'laser ablation' have been demonstrated by scientists in Japan.
Takashi Yabe and colleagues of the Tokyo Institute of Technology used a powerful laser and a new kind of 'ablation target' to propel paper airplanes. This work resurrects an idea that was first proposed in the 1970s as a method of powering spacecraft. The researchers have calculated that the technique could be scaled up to make small lightweight aircraft to monitor the atmosphere or volcanoes (Appl. Phys. Lett. 80 4318).
When a laser beam hits an object, atoms can be ejected from its surface in a process known as laser ablation. These atoms depart with a certain momentum, and impart an equal and opposite momentum to the object.
This led scientists to suggest that a laser on Earth could be used to propel a spacecraft with an 'ablation target' attached to it. In recent years, the potential of the technique has been proved by the launch of several miniature rockets, each weighing tens of grams.
Now Yabe's team has shown that the technique could also be used to fly small aircraft. They successfully propelled two small airplanes - which were several centimeters long and weighed 0.1 and 0.2 grams - up to speeds of 1.4 ms-1.
The ablation targets on the aircraft were both made of a piece of aluminum foil 0.1 mm thick and with an area of several square millimeters. One target was coated with clear acrylic, and the other had a layer of water placed on it. Load cells on each plane recorded the push produced when a pulse from an yttrium-aluminum-garnet laser was focused onto the targets. Each pulse supplied 590 mJ of energy and lasted 5 ns.
According to the team, the two-layer structure of their targets is the key to the success of the airplanes. In simulations, they showed that in single-layer targets - like those used in used in earlier attempts - most of the laser energy is absorbed by gas atoms just above the surface of the target. This leaves just a few percent of the energy to drive the target, and only a small impulse is generated.
But in the layered targets, the simulations showed that the gas atoms ejected from the target get trapped between the layers and impart a much greater momentum to the target as they are subsequently forced out.
Yabe and co-workers found that their airplanes received impulses three times greater those received by airplanes with single-layered targets. But they say that they need to find a way to continually refresh the target - or make the whole aircraft from the ablation material - before the airplanes can be developed into a practical device. They even speculate that a laser could be used to periodically deform a shape-memory alloy on the aircraft, without the need for ablation.
Author
Katie Pennicott is editor of
PhysicsWeb.
 |  |  |  |  |  |  |
| © 2024 SPIE Europe |
|
